1. Bending machine should be placed on solid smooth place, must be used before and after the iron wheel symmetric wedge tight triangle wood, should have enough space around the equipment.
2. The irrelevant personnel prohibited from entering the work area, so as not to pull (steel or steel broken up cuts.
3. Bending machine switch must remain sensitive, when using, should check all parts are in good condition, and confirmed by the test run normal rear can begin to work.
4. The operation will be reinforced to bend a head of inserted in the clearance between the wheel fixed pin, the other end fixed pin, close to the fuselage and compaction, moreover must pay attention to the fuselage pin does Ann in the side of the block reinforcement, before start the machine.
5. No bending over the diameter of the steel bar machinery factory regulations; Such as bending steel with scale, must take the goggles.
6. Steel plug should be paid attention to when working position and direction of rotation, may not be the right direction, to prevent harm.
Bend a long bar, due specialist support bar; Support of the people should be stood outside the bending direction, and follow the operating personnel's command. Shall not be arbitrarily push and pull.
關(guān)閉返回